Warning E15: current detection - unable to turn off current
a) This failure means the “current testing – current turn-off failure”. Use it again after restarting the instrument. If this failure occurs again, find out the problem. If no problem is discovered, it will be caused by interference. At this time, continue the use by ignoring this problem.
b) Plug off the main control board J12 and restart the instrument for retest. If this failure is eliminated, try replacing the DB9 wiring harness and laser power supply.
c) If, however, this failure is not eliminated, try replacing the current Hall sensor and main control board of main console.
Related Articles
Warning E16: detection to laser emission current is too large/small
a) This failure means “current testing – laser emission current is tested too large/small”. Use it again after restarting the instrument. If this failure still occurs, find out the problem. At this time, continue the use by ignoring this problem. ...
Warning W06
a) 此故障代表“手柄治疗头温度超出上限”，仅在ready状态下进行检测。 b) 如果手柄ready状态下不制冷或温度升高，请参照 手柄不制冷解决故障。 c) 如果手柄能够制冷，此项检测极有可能是手柄长时间以高能量出光导致的。重新按下ready按键后，可以继续使用。 d) 如果手柄制冷，长按“W06”5次后进入后台，输入密码“78652818”后，显示温度和实际不一致，则为手柄温度传感器故障，需检查传感器线束是否松动，如无问题则需更换手柄控制板。 ...
Warning E05: the failure of water pump
Prepare tools as below: Multimeter,tweezers The inspection procedure of warning E05 When the machine prompt E05,first we need to enter the interface of "the engineering data checking & disable warning pop-up message",check the data of “water ...
Unable to start the machine (abnormal power-on)
a) Check whether ~220/110V voltage of power socket is normal and whether the power wire is plugged tightly. Make sure the air switch is in “off” state. b) Make sure the contactor that always has the alternating current with power supply voltage is ...
Warning E11
说明： 由于版本不兼容性，主机软件版本L0-A-1.0.129、L0-A-1.0.133、L0-A-1.0.134不兼容手柄软件版本L4-A-1.0.001(或基于此版本定制版本) 。维修前请核对是否为使用此版本搭配导致。 a) 此故障代表“与手柄通讯异常”。 b) 可以通过尝试更换手柄来缩小诊断范围。 c) 如果判断为主机问题，且检查手柄显示屏或指示灯有显示，则检查主机主控板P5.7、P5.8与主机端手柄插口，是否断线或接触不良。 ...